160mm Y Tee pipe fitting mould

Proper use and maintenance of the  pipe fitting mold is also the main factor to improve the quality of the mold. Proper use of pipe fitting mold requires regular maintenance, guide rod, guide sleeve and other parts in relative motion should be regularly filled with lubricating oil. Before forming each mold, a lubricant or release agent should be sprayed onto the surface of the molded part. Strengthen the surface of the main part of the die of pipe fittings to improve the wear resistance of the surface, so as to better improve the quality; For surface reinforcement, different reinforcement methods should be selected according to the different uses of pipeline die.For cleaning, hot and cold media channels are frequently rinsed with detergent. Due to the geometry of the channel, mechanical cleaning of sediment is not possible, and many manufacturers provide detergents and special cleaning equipment. Threaded connections, supports, bolts and water intake lines should also be checked for damage to the outside of the mold to determine if they need to be replaced to ensure they are secured to the mold. Compressed air is used to drain water and hot air is used to dry the cooling system before storing the irrigation pipe mold. After production, the mold must be carefully removed from plastic residue. Soap and water are recommended to remove residual material and other sediment, and then the mold must be carefully dried. Before storage, rust stains left by condensed water and intrusive materials must be removed; Depending on the degree of chemical attack, rust can be removed with an abrasive or polish. 

At the end of each maintenance job, pipe fitting molds should be carefully dried and lightly coated with creosote, especially for movable parts such as push rod assemblies, sliders and lifters. If stored for a long time, wrap it in oil paper. It is especially important to grease and wrap the mould with oil paper when the storage conditions are not met. All observations and maintenance of the mold should be recorded on the mold card.